Suppose you would like to select a method to protect the privacy and integrity of wireless data. Which one of the following methods should you avoid because it has been deprecated?

Which of the following describes the Rapid PVST+ protocol?

Which options are not one of the manageable QoS characteristics of network traffic? (Choose two)

Refer to the exhibit. A new subnet with 60 hosts has been added to the network. Which subnet address should this network use to provide enough usable addresses while wasting the fewest addresses?

Of the different public cloud WAN options, which have quality of service capabilities to ensure end-to-end application requirements? (Choose three)

Refer to the diagram. What is the name of the device referenced with the arrow, assuming the traffic coming from the wireless clients followed the dashed path?

During a maintenance window, you make some changes to R2. You document these changes in your configuration management system. Later that night, you are called in to fix an issue that requires you to make additional changes to R2. The next morning your co-worker addresses another issue but this time on R1. All of these changes are documented properly but neither you or nor your coworker discuss the changes. These changes stay implemented for months. What is this best described as?

Review the topology. All subnets exist in OSPF area 0. Which command, if issued on R3, would show all the LSAs known by R3?

What is the correct order for the DHCP process?

Which feature is required for multiple VLANs to span multiple switches?

What versions of Wi-Fi Protected Access (WPA) were defined after the IEEE ratified the IEEE 802.11i security standard? (Choose two)

Which of the following components stores startup configuration?

Which of the following four TCP/IP layers covers the same processes as the two lower OSI layers?

Which of these are QoS requirements when designing a Cisco TelePresence video network? (Choose two)

You are implementing a VLSM network. You are using the Class B network of 172.16.0.0/16 and need to create 256 networks from this. The fifth network will then be subnetted into /30 networks.
What is the subnet ID of the fourth /30 network?

Historically, your organization has modified the network device configuration by logging in to the local devices manually. Today, your new CIO has enforced that all configuration changes should be completed on a server in the data center and then pushed out. Which answer lists the correct term for this new approach to configuration? 

What is the scope of an IPv6 multicast address that starts with FF02?

What is the name of the firewall feature that, when used, can maintain a historical database of each connection through a device: Where it was sourced, destined, and which protocol and protocol port it was using?

From the following options, what are the required REST API attributes? (Choose two)

Routing tables can be populated in a number of different ways. Which of the following describes the static routing route type.

A switch’s port Gi0/1 has been correctly enabled with port security. The configuration sets the violation mode to restrict. A frame that violates the port security policy enters the interface, followed by a frame that does not. Which of the following answers correctly describe what happens in this scenario? (Choose two)

Identify the statements that describe the SPF algorithm. (Choose two)

Which of these are QoS requirements when designing a Cisco voice network? (Choose two)

Which command can be used to prevent syslog messages from interrupting the commands that you are currently typing in?

Which of the following behaviors are applied to a low latency queue in a Cisco router or switch? (Choose two)

Which of the following cloud services is most likely to be purchased and then used to later install your own software applications?

Given the output from a working OSPF router, as seen in the exhibit, how many neighboring routers exist?

In a network that uses OSPF, you need to configure a default route to 203.0.113.1 on one router that will then be advertised to the other routers.
What command should be used first?

What protocols exist to negotiate EtherChannel creation and maintenance? (Choose two)

What should be checked when troubleshooting IPv6 end-to-end connectivity? (Choose three)

Which of the following describes a dynamic NAT configuration?

Review the topology diagram. Network 10.123.0.0/24 is the backbone area. Network 10.12.0.0/24 is area 1, and network 10.34.0.0/29 is in area 2. Which of the following are true? (Choose three)

When operating in trunk mode, what command is used to shut off DTP?

In Software-Defined Access (SDA), which of the answers are part of the overlay data plane?

To connect a Cisco wireless LAN controller to a wired network, which of the following would you use? Assume that this connection will carry traffic to and from APs.

R3 has a static route configured that points toward the service provider. What command could you use to have R3 advertise an OSPFv3 default route to the internal network, regardless of whether R3 had its default static route?

A Cisco Catalyst switch connects to what should be individual user PCs. Each port has the same port security configuration, configured as follows:
interface range gigabitethernet 0/1 - 24
switchport mode access
switchport port-security
switchport port-security mac-address sticky
Which of the following answers describe the result of the port security configuration created with these commands? (Choose two)

You can use output filters in combination with any show command. Which of the following displays the output lines from a specific point, starting with the line that matches the filtering expression?

You have a Class B addressing space with a subnet mask of /26.
How many subnets were created from the original Class B addressing space?

What is the multicast address for hello packets by default on OSPFv3?

Refer to the exhibit. The network administrator normally establishes a Telnet session with the switch from host A. However, host A is unavailable. The administrator's attempt to telnet to the switch from host B fails, but pings to the other two hosts are successful. What is the issue?

Which three statements accurately describe Layer 2 Ethernet switches? (Choose three)

Which of the following describes the manual IP addressing mechanism when configuring a DHCP server?

You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the maximum number of subnets. Which network address and subnet mask meet this requirement?

The show port-security interface f0/1 command lists a port status of Secure-shutdown. Which of the following answer must be true about this interface at this time?

Using the exhibit as a reference, what is a valid key?

A router has two Fast Ethernet interfaces and needs to connect to four VLANs in the local network. How can you accomplish this task, using the fewest physical interfaces and without decreasing network performance?

What network mask should be used with Class B network to create 40 subnets?

Which two benefits are provided by using a hierarchical addressing network addressing scheme? (Choose two)

Which hash method is used by default when using the enable secret Cisco IOS command?

Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links are operating at the same bandwidth? (Choose three)

Which of the following dynamic routing protocols are Distance Vector routing protocols? (Choose two)

Which of the following use cases are matching the UTP Ethernet media type?

What options are required criteria for a service to be a cloud service? (Choose two)

Which of the following describes an unicast type of network communication?